Site survey & pathway plan
Review equipment locations, ceiling space, wall access, risers and practical routes before cable is pulled.
Cat5, Cat6 & Cat7 · labelled and testedStructured & data cabling in Toronto & the GTA.
We pull Cat5, Cat6 and Cat7 cable, terminate it at wall jacks and a patch panel, label both ends and check every run for offices, retail, warehouses, clinics and homes across Toronto and the GTA.
What’s included.
Every job runs through the same six steps: survey the routes, pull the cable, terminate the jacks, land it all on a patch panel, label both ends and check the links.
Cat5, Cat6 & Cat7 runs
Horizontal cabling selected around distance, expected performance, PoE requirements and the property.
Jacks & faceplates
Clean workstation, display, phone, camera and wireless access point terminations at each endpoint.
Patch panels & racks
Centralized termination, patching and cable management that makes the network easier to service.
Labels & organization
Consistent identification at both ends so technicians can trace connections without guesswork.
Verification & handover
Installed links are checked against the agreed scope and the finished network is explained clearly.
The same work, in any building.
In an office we run cable above ceilings and through risers out to desks and access points. In a house we run it through walls, attics and basements, ideally before the drywall goes up.
Commercial structured cabling
- Workstations, VoIP phones and shared equipment
- PoE cameras, access control and wireless access points
- Office expansions, tenant improvements and relocations
- Warehouse, retail, clinic and multi-site infrastructure
- Rack, patch-panel and IDF/MDF organization
Residential structured cabling
- Home offices, TVs, gaming and media locations
- Wired Wi-Fi access points for dependable coverage
- Camera, doorbell and smart-home pathways
- Renovation and new-construction pre-wiring
- Central network panel and equipment organization
Room to add drops later.
We leave spare room in the pathways and free ports on the patch panel, so adding a desk or a camera later means pulling one more cable instead of reopening walls.
Cable selection
Cat5, Cat6 or Cat7 is selected according to expected speed, link distance, pathway conditions, equipment and future plans.
Power over Ethernet
Access points, cameras, phones and access devices can share data and power over suitable cabling when the complete system is planned for it.
Pathway coordination
Routes are coordinated around the building, other trades and the agreed project requirements, including supports and penetrations within scope.
Documentation
Clear labels and an understandable handover reduce the time needed to trace, change or expand the network later.
Common questions.
Is data cabling the same as structured cabling?
Mostly, yes. Data cabling is the everyday name for the Cat5, Cat6, Cat7 or fiber cables that carry your network. Structured cabling is the organized way of installing it: every run goes back to a patch panel, is labelled at both ends and is tested, so it is easy to add to and repair later.
Should I install Cat5, Cat6 or Cat7 cabling?
The right cable depends on link speed, distance, pathway space, interference and future plans. Cat5 suits basic connections, Cat6 is a strong fit for most data drops, and Cat7 is a shielded cable for higher-performance runs or areas with more interference.
Can structured cabling be added to an existing building?
Yes. Existing offices and homes can often be cabled using ceiling space, conduit, unfinished areas and carefully selected wall routes. A site assessment identifies practical pathways before installation.
What is included in a structured cabling installation?
A project can include cable routes, Cat5, Cat6 or Cat7 runs, jacks, faceplates, patch panels, racks, cable management, labels, connection checks and a clear handover. Scope is matched to the property.
How many data drops should I plan for?
Drop count should reflect workstations, phones, printers, access points, cameras, displays and future changes. Planning spare capacity during construction is usually easier than adding pathways later.
Areas we serve.
Raptors Cabling handles structured and data cabling for offices, retail stores, warehouses, clinics, condos and homes in Toronto, North York, Scarborough, Etobicoke, Mississauga, Markham, Vaughan, Richmond Hill, Brampton, Oakville, Whitby, Ajax, Pickering, Oshawa and Durham Region. Every job starts with a site visit, so the quote matches the building rather than a guess.
Call (289) 943-3595 or request a free quote.
Get a free cabling quote.
Tell us about the property, your timing and roughly how many connections you need. We visit, then send a clear, free quote.